Cooler Master MasterBox NR600 Case Review

A Closer Look: Interior

The same matte black finish from the outside of the NR600 has been brought to the interior of the case. The NR600 has support for full sized ATX motherboard with plenty of room for cable routing. Your options for route include two cutouts at the top, two cutouts at the bottom and two grommets to the right of the motherboard.

The NR600 contains a full PSU shroud with a cutout at the front giving you about 70mm of radiator clearance. Cooler Master has also included three 2.5” drive mounting points on top of the shroud if you wish to show off your drive.

Looking toward the front, you have mounting points for three 120mm fans and/or up to a 360mm radiator. The NR600 comes with a single 120mm fan pre-installed on the front panel which acts as an intake.

At the back of the case, you have a second pre-installed 120mm fan as an exhaust fan.

At the back of the motherboard tray are various tie-downs at all sides of the case as well as two 2.5” drive mounting points below the processor cutout.

Under the PSU shroud is a riveted in HDD cage that has storage for up to three 3.5” drives.

Subscribe
Notify of
0 Comments
Inline Feedbacks
View all comments