Cooler Master MasterBox NR600 Case Review: Page 5 of 7

Posted by James Keir on Tuesday, March 19, 2019 - 8:00am

A Closer Look: Interior

The same matte black finish from the outside of the NR600 has been brought to the interior of the case. The NR600 has support for full sized ATX motherboard with plenty of room for cable routing. Your options for route include two cutouts at the top, two cutouts at the bottom and two grommets to the right of the motherboard.

Cooler Master NR600

The NR600 contains a full PSU shroud with a cutout at the front giving you about 70mm of radiator clearance. Cooler Master has also included three 2.5” drive mounting points on top of the shroud if you wish to show off your drive.

Cooler Master NR600

Looking toward the front, you have mounting points for three 120mm fans and/or up to a 360mm radiator. The NR600 comes with a single 120mm fan pre-installed on the front panel which acts as an intake.

Cooler Master NR600

At the back of the case, you have a second pre-installed 120mm fan as an exhaust fan.

Cooler Master NR600

At the back of the motherboard tray are various tie-downs at all sides of the case as well as two 2.5” drive mounting points below the processor cutout.

Cooler Master NR600

Under the PSU shroud is a riveted in HDD cage that has storage for up to three 3.5” drives.

Cooler Master NR600

Category: 

Linode VPS Hosting